Screw Fixings Install Guide

Step one

Make Sure You Have Everything

To install your slate house sign, you will need the sign itself, screws, wall plugs, a drill equipped with a 6.5mm masonry bit, and a PZ2 screwdriver.

Step two

Decide Where You Want the Sign to Go

We recommend drilling directly into the brick for the best result, though drilling into the mortar is an acceptable alternative if it's easier. Once you have positioned the sign, use a pen to mark the wall through the sign's pre-drilled holes.

Step three

Drill Out the Holes in the Wall

Drill into the wall/surface where the dots are using an 6.5mm masonry drill bit. Drill nice and deep so the wall plugs sit flush in each hole.

Step four

Push the Wall Plugs in the Holes

Push the wall plugs into the newly-drilled wall holes, until the entire wall plug sits flush against the wall. If they don't fit flush, use your drill to make the holes deeper.

Step five

Tighten the Screws into the Wall Plugs

With your screwdriver and screws to hand, put the sign back onto the surface, aligning the screw holes with the newly-inserted wall plugs and carefully screw the sign into place. Once all the screws are tightened, you're done!